Bar weights slide in and screwed down tight. So, I thought I would share my new found wisdom.įor (1) I used a couple of pieces of refrigerator water maker tubing to make shims.

It took me the better part of an afternoon, but I overcame all 3. The 3 main gotchas are (1) stock bar weights wont fit because bar diameter is too large, (2) bars are 3/4 of an inch longer than stock so they look dorky, and (3) you need to drill some holes to remount the controls. As usual with me, I didn’t do a lot of research before I bought them I looked at some of the threads after they arrived and found out what I was facing. So I bought a set of these bars because the stock bars don’t quite fit right.